Barebone Waveshare

296x: 128, 2.9inch E-Ink Display Module, SPI Interface This is an E-Ink display module, 2.9inch, 296x: 128 resolution, with embedded controller, communicating via SPI interface, supports parti… (continua)

800X480, 7.5inch E-Ink Raw Display, SPI Interface, Without PCB This is an E-Ink raw display, 7.5inch, 800X480 resolution, with embedded controller, communicating via SPI interface. Due to the… (continua)

200x: 200, 1.54inch E-Ink Display Module, Three-Color, SPI Interface This is an E-Ink display module, 1.54inch, 200x: 200 resolution, with embedded controller, communicating via SPI interface,… (continua)

This RPi Relay Board B with 8-ch relays in high quality can load up to 5A 250V AC or 5A 30V DC. Onboard standard Pi 40PIN GPIO extension header, supports Raspberry Pi series boards and Jetson… (continua)

With 320x: 240 Resolution, 65K RGB Colors Clear and Colorful Displaying Effect. with SPI Interface, requires minimal IO pins Embedded ST7789VW Driver, Using SPI Bus; 2.6 5.5V operating voltag… (continua)

Supports all AVR devices with ISP or PDI interface, and certain 51 Devices Programs both Flash and EEPROM. Supports Fuses and Lock Bit Programming Based on AT AVRISP mkII firmware. Upgradabl… (continua)

Onboard Standard Pi 40PIN GPIO extension header, supports Raspberry Pi series boards and Jetson Nano With 6 available microstepping modes, configured with the DIP switches: full-step, half-ste… (continua)

This Converter support USB to RS485 bidirectional conversion. Due to its stable communication, it's ideal for industrial control equipments and/or applications with high communication requir… (continua)

M. 2 interface power supply is limited to 1.5A, if it causes problems such as slowing down of solid state or other equipment, it is recommended to buy version B. Both USB 3/4 and HDMI1 need t… (continua)

Onboard ESP8266, supports development; 802.11b/g/n protocol Interface: 3-wire SPI, 4-wire SPI default ; Operating voltage: 5V; Operating current: 50 m. A 100 m. A; Outline dimension: 29.57mm x… (continua)

Note: Not compatible with Jetson Nano 2GB Developer Kit Chip: Intel 8265AC. Bands: 2.4GHz/5GHz. Speed: 300Mbps/867Mbps Wi Fi protocol: 802.11ac. Bluetooth version: 4.2. NIC interface: NGFF … (continua)

XBee USB Adapter is a UART communication board which supports XBee connectivity, features UART interface, USB interface, and onboard buttons/LEDs, provides an easy way for developing/debugging… (continua)

This is an E-Ink display module, 1.54inch, 200x: 200 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra low powe… (continua)

A 1.44-inch LCD expansion board for Raspberry Pi, with 128x: 128 resolution and internal controller, which can use SPI interface to communicate Designed for Raspberry Pi 40pin GPIO interface, … (continua)

With standard 40PIN GPIO header, for Raspberry Pi series boards. Onboard USB TO UART converter, for serial debugging; Brings the UART control interface, for connecting host boards like STM32;… (continua)

This is an E-Ink display HAT for Raspberry Pi, 2.13inch, V4 latest version 250x: 122 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Due to th… (continua)

Designed for Raspberry Pi 40pin GPIO interface, suitable for Raspberry Pi series motherboard/Jetson Nano Lead out SPI control interface, suitable for Raspberry Pi/Nucleo main control board, et… (continua)

This is an E-Ink display module, 4.2inch, 400x: 300 resolution, with embedded controller, communicating via SPI interface. Due to the advantages like ultra low power consumption, wide viewing… (continua)

Specially design for Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards; Supports SIM application toolkit: GSM 11.14 Release 99 Supports SMS, phone call, GPRS, DTMF,… (continua)

128 x 128 resolution OLED display, 65K color, can clearly display color pictures Use SPI control to ensure that it does not take up too many interface pins Provide complete supporting informat… (continua)

5inch Capacitive Touch Display for Raspberry Pi, 800 x 480, TFT Wide Angle, MIPI DSI Interface. DSI interface, refresh rate up to 60Hz. Capacitive touch panel, support 5-point touch. Temper… (continua)