Barebone Waveshare

Adatto per valutare il Raspberry Pi CM4 o essere integrato nei prodotti finali. Potenti funzioni in un corpo delle dimensioni di una carta di Presa standard CM4 e intestazione Raspberry Pi 40… (continua)

Support Raspberry Pi Pico expansion board ecosystem to satisfy creative IoT application development. Xtensa single-core 32-bit LX7 microprocessor, ESP32-S2FH4, support clock frequency up to 24… (continua)

onboard CAN transceiver SN65HVD230 powered from 3.3V features ESD protection connecting MCUs to the CAN network compatible with PCA82C250

Processor: TI Sitara AM335x, 1GHz, 2000 MIPS Memory SDRAM: 512MB DDR3L 800MHZ eMMC Flash:Rev B: 2GB discontinued ;Rev C: 4GB as of 2014.05.21 SD/MMC Connector for microSD; Operating Power: 5V0… (continua)

Supports AVR Studio 4/5/6 or higher versiondelivered with firmware for AVR Studio 5, can be updated to support AVR Studio 4/6 Supports all AVR devices with ISP or PDI interface, including XMEG… (continua)

Waveshare OpenEP4CE6-C Standard EP4CE6 EP4CE6E22C8N FPGA NIOS II ALTERA Cyclone IV Development Board

for STM8 and STM32 MCUs Atollic, IAR, Keil or TASKING integrated development environments 5 V power supplied by a USB connector USB 2.0 full speed compatible interface USB standard A to mini B cable

with STM32F401RE MCU supports Arduino integrates the ST-LINK/V2-1 debugger/programmer Two types of extension resources mbed-enabled mbed. org

Onboard 500 m. A self-recovery fuse to avoid harming by short circuit Dual voltage output 3.3V/5V, easy for debugging/programming Standard USB interface for direct connection to PC Debugging/… (continua)

0.95 pollici RGB OLED, curved/orizzontale pinheader; Driver Chip:Solid State Drives: 1331 Interfaccia: SPI Risoluzione: 96 x 64; angolo visibile 160 ° Display Size:0.95inch;OPERATING TEMP:-207… (continua)

Onboard ADS1256, 8ch 24bit ADC ad alta precisione 4ch differenziale input, frequenza di campionamento 30ksps. Onboard DAC8532, 2ch 16bit DAC ad alta precisione Interfaccia di ingresso integr… (continua)

Minimal ready-to-run system, integrates clock circuit, USB power management, USB connector, etc. Onboard 64M Bit SDRAM. All the I/O ports are accessible on the pin headers. JTAG/SWD program… (continua)

Onboard voltage translator, compatible with 3.3V/5V operating voltage I2C communication interface, control the module on/off via IO pins Ranging distance: 40 4000mm,ranging accuracy: ±5%, rang… (continua)

Onboard voltage level translator, compatible with 3.3V/5V operating voltage Supports I2C default, configurable slave address, supports SPI, switch to SPI via I/O setting Humidity sensing: 010… (continua)

I2C controlled, expands 2 signal pins as 16 I/O pins

I2C controlled, expands 2 signal pins as 16 I/O pins I2C address configurable by shorting the A0/A1/A2 jumpers Provides two connector options: PH2.0 terminal and/or solder pads, allows multi I… (continua)

The CC Debugger is primarily used for debugging and programming the flash on CCxxxx 8051-based System-on-Chip SoC devices from Texas Instruments CC Debugger also supports CCxxxx RF transceiver… (continua)

USB TO RS232, USB TO RS485, USB TO TTL UART, adopt original FT232RL, fast communicating, stable and reliable, better compatibility Onboard unibody power supply isolation, provides stable isol… (continua)

This is a 24-bit high precision barometric pressure sensor, which allows accurate altitude tracing, as well as barometric pressure / temperature measuring Supports I2C default / SPI interface,… (continua)

Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards, Jetson Nano;Comes with development resources and manual examples for Raspberry Pi/Jetson Nano/Arduino/ST… (continua)

Raspberry Pi connectivity, compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+ I2C interface, only 2 pins are required for moving and light intensity sensing Onboard TSL25911FN light-to… (continua)