AF-Lightn-ing-PD PoE splitter support to isolated power and data for i-Pads and allows 10/100 Mbit/s data transmission; With RJ45 female connector power source and A-pple lightn-ing dc output 3.000-volt isolation between PoE and power out ; 10/100/1000 or 10/100 switches can be used; the device will negotiate at 10/100 full duplex rates; The max input voltage is up to 57 volts and the max output is 5 volts 2% error 10 watts 2 amps; The output voltage no load 5.2 volts; Input current in 48v; 265 ma input delivers 2 amps out; With Data and power pins either polarity for 1&2 3&6; 4&5 plus and 7&8 minus for IEEE 8020.3af Mode A or Mode B. This device provides a low-cost solution for delivering power and wired Ethernet data to a Lightn-ing device over 328ft of network cable;
This splitter allows control on CAT-5 e or CAT-6 network cables using either 802.3af standard or 48-volt passive PoE; 802.3at switches can also be used; but only 12 watts will be requested; Intended for use with any 802.3af or 802.3at PoE switch; this active PoE solution negotiates with the switch to activate the power and provide it to the client device; It is a compact and cost-effective power solution;
The PoE switch supplies 48 or 56 volts of DC at the source location; The higher DC voltage means the current is reduced by a factor of 9 compared to 5 volts, and then carried with 90% less loss over the Ethernet cable from the source, the 5v converter at the remote end allows you to extend the charge distance for this application up to 328ft or 100 meters.
Partner
